On the one hand, we distinguish between low band and high band. The low band covers the range from On the other hand, there are two different polarisations, namely horizontal and vertical, or left and right respectively. Switching between the two is controlled with the LNB supply voltage.
Er hat seine Lehre abgebrochen
From this it follows that each tuner input requires a dedicated line all the way to the LNB or multi-switch. Otherwise, the receiver will not be able to receive signals from the complete frequency range.
If receiver A requires a vertical signal and sends 13 V to the LNB while receiver B is looking for a horizontal signal and therefore transmits 18 V via the same cable then this would result in receiver B being prioritised as the higher voltage overrules the lower voltage with regard to the selected polarisation in the LNB. So as far as satellite reception is concerned, it has been evident right from the beginning that signal distribution requires a substantial amount of planning and infrastructure.
In the case of an apartment building, for instance, an individual coax cable has to be rtl neue dating show for each wall outlet from a central distribution point. Ring distribution by definition means that a single signal access is used to distribute rtl neue dating show from one wall outlet to the next, no matter how many of rtl neue dating show you need to cover.
Temptation Island - Valentinstagsgeschenk! Jetzt schon die ersten 30 Minuten der 2. Staffel schauen
Smart planning and a signal amplifier here and there thus are all that is required to connect dozens of apartments to cable TV. In most cases, basic cabling will be available, but how can you best use it for satellite reception, and how can you use your twin tuner receiver if only one cable leads to the wall outlet in the living room? How does SCR work?
Welcome to Scribd!
In general, SCR comes in two different varieties: The first one has all control technology built right into the LNB, which means no additional equipment other than SCR-compatible receivers is required. The second variant is more complex and only works with SCR-compatible multi-switches and distributors, yet offers a vast variety of different set-ups and establishes an extremely versatile system.
With SCR, each active receiver is allocated a specific frequency range out of an overall range from to MHz. Up to eight receivers per cable can be accommodated according to current SRC specifications which define the following:.